Tips for Dry Gas Seals

Oct 08, 2024

Leave a message

‌ Tips for dry gas seals mainly include the following aspects:

‌ Choose the right groove type: The end face of the dry gas seal is designed with grooves ranging from a few microns to more than ten microns deep. These grooves are divided into two categories: unidirectional and bidirectional. The unidirectional groove type is suitable for units that rotate in one direction, which can produce greater opening force and air film stiffness, and is suitable for use in low-speed and high-vibration environments; while the bidirectional groove type is suitable for units that can rotate forward and reverse, and is not easily damaged by reversal.

‌ Control the sealing gap: The size of the sealing gap has an important influence on the sealing effect. A gap that is too large will increase the leakage, and a gap that is too small will easily cause the two sealing surfaces to contact, resulting in sealing failure. Usually, the sealing gap is kept at around a few microns, which can effectively prevent leakage and ensure non-contact operation of the sealing surface.

‌ Maintain air film stability: Dry gas seals rely on the stability of the air film to maintain the sealing effect. The stiffness of the air film needs to be strong enough to ensure that the two sealing end faces are completely separated and maintain a certain gap. At the same time, the thickness and pressure distribution of the air film also need to be precisely controlled to ensure a stable sealing effect under various working conditions.

Prevent end face contact: During the operation of the dry gas seal, if the friction heat cannot be dissipated in time, the end face will overheat, causing the seal to deform and fail. Therefore, it is necessary to ensure that the sealing surface operates in a non-contact state to avoid wear and heat accumulation caused by contact.

Send Inquiry